I have used this Wilson pistol gage for quite a while now and all of the FMJ projectiles I have loaded have never had any issues.
I recently started casting and finally sized and loaded some test rounds of these first cast projectiles. http://castboolits.gunloads.com/show...-First-boolits
I am sizing with a Lee .358 sizing die and once I got the first couple of test rounds in the case, no primer or powder just adjusting the reloading dies, I dropped them into the Wilson gage and they do not drop all the way in like the FMJs. I can push them down and they will seat but I noticed that the gage was scrapping the powder coating off the projectile where the case gage necks down inside the gage.
I can freely drop these into a G19 or Shield barrel but for some reason they have issues seating all the way into the 9mm gage.
Has anyone seen anything like this? I've tried to find the dimensions of the Wilson gage but haven't found it yet.
Thanks.