I’ve been fighting with flow using my new to me RCBS Pro Melt. The flow will dump lead in one pour, drip lead the next, then pour correctly. No matter how I adjust it just will not pour consistently. Have been fighting this issue with each session.
Last night I sat down again to work with this pot. I have searched on line for solutions and tried them all. Nothing helped. Discouraged, I set an I set an mold under the spout and began to empty the pot. Upon opening the valve I noticed the “split lug” that the handle attaches to on the left side is loose. So loose that I can lift it up and down close to an eighth of an inch. This I believe is my problem causing the inconsistent flow rates.
It was late and I only spent a short time inspecting the “lug” after cleaning up. From what I can tell I’ll have to take the unit apart in order to tighten it up. I assume there is a nut encased in the unit that secures this “lug”. Do I need to drill out the rivets to get it apart? Is there a schematic for these available? Any advise, tips or tricks to getting this done?
Hope I’ve explained the issue properly. Thanks for any help!
Rob