Been building a casting table, on casters so i can move it around the shop ,, I have a Master Caster ( one arm bandit ) pulled off the therm. cover , pulled the ins. back to weld a 1/4"x 20 nut to the bottom of pot for my " HATCH PID set-up " thermal wire ???? I see 2 holes 1/4" x 20 at the bottom of the pot ,,,,, does " one " think they ( MC ) put the holes there for just that purpose ??
Sure would be nice not to have to weld on it.
I'll be hav'n coffee till hear from ya'll .
Hootmix.