Anyone casting for a 9mm or .40 Glock?

[44Blam]

I've got a Glock 35 and I cast/load for .357 sig and .40 S&W.

The .357 sig is a 9mm boolit that one is an Accurate molds 35-125YG. I shoot these out of a KKM barrel with AA7 powder. They are super sonic and have a nice flat trajectory. Very accurate.

The 40 boolits I load are a Noe mold HTC402-188-WFN. I shoot these out of a .40 KKM barrel with AA7 powder. This mold makes flat tip/cup points/hollow points. I tend to cast the cup points. This is also very accurate.

If I'm shooting plated bullets, I shoot them out of the factory barrel. Otherwise, I shoot lead through a KKM barrel. I know everyone says you can shoot lead out of a Glock barrel, but I found that the factory barrel mildly leadded and my accuracy was poor and erratic. I switched to the KKM barrel and the accuracy is very good and I get no leadding.

[Lagamor]

I’ll jump into a six year old thread. I have a couple of MP Molds that are great, but I just bought a couple of Accurate molds and I like them even more.
I’ve moving towards keeping it simple, no hollow points, or lube grooves. Truncated cones with bevel bases to make loading simple.

[kevin c]

I have Lee, Accurate and MP molds in 9mm. I use the MP molds the most, and have the most variants from MP as well. The Accurate molds are great, but I like the higher production rate of MP's eight cavity molds.

[cwlongshot]

I for one like to see older threads “rehashed”. Good info for all is usually the result!

Something that wasnt as common back in ‘13 is powder coating. It IS A JACKET and negates worries about stock glock barrels.

I have shot untold numbers thru my competition G35 factory barrel. I also have KKM/Lone Wolf/ & Silencer-CO barrels. All shoot well. But the glock works real well with my fat forties! I cannot shoot 402 reliably from my KKM’s. They shoot very well, but need assist to completely chamber.

I use a LEE 358-125 & Accurate 360-135 RD for my 357 Sig barrels and gun.

Sorry I dont do 9MM.

Good luck

CW