Got this mold a bit ago, am excited to get some venison on the table.
Plan to use it in a 06 (I know it was designed for 30-30) plan to powder coat and use a gas check.
I don't ever get long shots on deer in North Louisiana where I hunt. 100 yards would be amazingly far...most shots are 35-50 yard shots.
My question is alloy and velocity targets? 50/50 with a touch of tin pushed to 2100?
I guess how I get there (load, powder charge and type etc) will be my main testing development but wanted to poll the audience on any experience with this boolit or one similar and what alloy/velocity it will work well for short ranges. Expansion is always desired but with the WFN don't think it should be a problem unless I'm driving it too fast or on the opposite end too hard.
I nearly always take the high shoulder shot and anchor them home....woods are too thick and soggy bottom too close to have them run a mile and track them before dark.
So, any suggestions? Any experience with the ranch dog molds in 30 cal?
Sent from my Moto G Play using Tapatalk