So I'm having troubles finding proper load data. I cast my own bullets from a 2 cavity .356 124gr round nose mold from Lee. They came out just fine, I dropped them immediately in water cuz some light research says that's helpful. The lead content is... unknown. I bought about 10 ingots from my local shop. Some were labeled WW which I assume are wheel weights. And some were labeled 60/40. Either way this was just a proof of concept for plinking ammo. I'm using Titegroup and I'm using the load data that came with the Lee dies as the data on the powder has 115gr and I can't seem to narrow down two consistent sources. I just kinda started with 3.6 as that was what the Lee insert said was for a 125gr Lead Cast bullet. Is this safe? What should I adjust? I also have die questions but those are for a different place on the forum I'd assume. :P