I never thought I would like a plastic gun.
Recently, I have been shooting and falling in love with a Springfield XDM 45acp 5 inch service pistol. Very reliable so far and will feed anything I can load in it.
I picked up an early Springfield XD 45acp for cheap as a backup to my XDM 45acp service 5 inch since it uses the same magazines.
I hear and read about problems with some of the early XD pistols not wanting to feed SWC ammunition. Basically anything that has a fairly sharp shoulder just in front of the case.
I looked at the bottom of the slide and there is NO hump below the breechface, so this one has not been updated.
I have molds for 452374, 452460, H&G 68, and Lee 230 tc.
Which ones would have the best chance of working properly with this pistol?
I pick it up in a few days and need to get some ammo ready for a trial run.
Even if I can't get it to work with cast, I got it cheap enough I could afford to just run new ammo in it if I absolutely needed to but would very much prefer to use my cast loads in it.