Lee PrecisionMidSouth Shooters SupplyTitan ReloadingRepackbox
WidenersSnyders JerkyRotoMetals2Inline Fabrication
Reloading Everything Load Data
Page 2 of 2 FirstFirst 12
Results 21 to 22 of 22

Thread: Glock slide refinishing. Help

  1. 07-24-2018, 10:08 PM #21
    Petrol & Powder
    Petrol & Powder is offline
    Banned
    Join Date
    Nov 2012
    Location
    Central Virginia
    Posts
    7,439
    43PU - As Randy said, Parkerizing is meant to hold oil. When it is properly oiled it is very rust resistant.

    I think that Glock slide turned out fine. Put some oil or grease on that puppy and it will last forever.
    Reply With Quote Reply With Quote
  2. 07-30-2018, 01:10 PM #22
    43PU
    43PU is offline
    Boolit Buddy 43PU's Avatar
    Join Date
    Jan 2013
    Location
    N.East Ky
    Posts
    355
    After I was done parking it I dipped it in boiling water then soaked it down with WD-40 while it was still hot then I dumped it in a tub of 0W-20 motor oil until it cooled down and I let it sit for 24 hrs after that I took some 0000 steel wool and rubbed it down
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check