I've got a few molds that were in my shop fire 3 years ago that have been soaking in a bucket of diesel. I've dug a few out and cleaned them up as much as I can. I have one from Mountain Molds that is a 452 double cavity that casts a plain based 340gn with 70% meplat and the second cavity casts a gas checked 350gn 90% meplat.
These used to shoot rather good in my Taurus Raging Bull 454. I cast a few and it looks like the alignment pins aren't keeping the mold halves lined up on center. The cast bullets are oblong at about .464".
I've tried moving the pins out further until it will just close, but it still doesn't line up.
I'd like to save the mold if I can. Any thoughts?