I have gotten back into casting after a period of absence from it. I used to melt wheel weights, flux (or what I thought fluxing was) and then cast from a bottom pour lee pot. I usually did this without making ingots and such. Is this not the preferred method? I started reading posts on this forum just recently, and it seems most of you are using two different lead pots. One to melt and clean alloy for ingots and a second one for making bullets when you are ready. When I first started casting it was pre internet days and you read a book or two and then went at it. Nobody to guide you and no youtube video demonstrations.
Trying to get the best bullet I can get.