I know this has been discussed somewhere surprised I couldn't find a sticky on the subject. I've bought several lyman and a couple Cramer hollow point molds .that have no pin . I can't afford 40 bucks for each one to send off to Eric at hollow points molds. What is the best way to DIY pins for the Lyman mold. The Cramer molds not sure if they can be DIY'ed . I've tried using drill bits and used JB weld to try and hold the pin in the wood handle I fashioned but the weld melts and wood piece falls off when pin gets heated up . So what have y'all been doing to fix this situation . Thanks for any info or help . Have a great labor day .