I did some searching on this site and a few others, there's really not a lot of load info out there for these. Even the Lyman 4th doesn't show any wadcutter loads. I bought this mold http://www.accuratemolds.com/bullet_...=43-190W-D.png, and it casts right at about 195 grains lubed with my alloy. So far, I have tried 5.5 gr of Bullseye, and 6 grains of Red Dot with good results. I'm wondering if any of you guys have any experience with 44 wadcutters, and what loads you prefer for yours. I have a plethora of other powders including Unique, 231, Titegroup and others. If you have suggestions, thanks for sharing!