Never heard of Red River Rick but went and looked. Care to elaborate on what makes them the best non-locking handles?
I’m easily distracted (case of late-onset ADD) so I went and did a little inventory. I was thinking most of my Lee handles had alignment problems but I noticed my worst alignment was with an RCBS set of handles which adds a little wear on the alignment pins if you are a little careless in closing.
I generally have only one mould for each caliber but the 38-55 and the 40-65s are an exception. Then again I have two and three of those calibers respectively. I have two 32-40s as well but as yet have not picked up a mould for the Ballard. Brooks recommends Saeco handles with his moulds so I have intended to replace that one and I don’t have a set of handles for the Creedmoor. Just for grins and giggles here the list I just made:
Caliber Mould/Handles
30-30 Lyman/Lee
32-20 LBT/Lee
32Spcl RCBS/Lee
32-40 LBT/Lee
35Rem RCBS/RCBS
35-40 Brooks/Lee *want to replace these.
38-55 Accurate RD Clone/Lee
38-55 LBT/Lee
38-55 Old West NASA/Lee
38-50 Moss/RCBS
40-63 Accurate/Lee
40-65 RCBS 350/Lee
40-65 BACo Money/Locking BACo
40-65 Saeco/Saeco
40-65 BACo Creedmoor/None
45-70 Accurate/Lee
I’ve got two I was gonna stock with Saeco; money permitting I’d probably replace some others - but if Red River Rick is better than Saeco they are also cheaper unless his shipping is over the top.
Guess I'm straying considerable distance from the path here ADD is hard on the original intent of these threads.