At a gun show last weekend where I bought a H&G 130 4 cavity mold and handles. Doesn't appear to have been used much all 4 cavities are clean no pitting, no dings. On the outside of the blocks and the sprue plate is is a little surface oxidation more like dirt than rust.
Looking to try it out tomorrow anything beyond the normal scrubbing with hot water and Dawn that I should do?
if the cavity's are clean and oil free I wouldn't even clean it.
other than getting it hot and washing it down real quick with some degreaser then casting with it a bit before lubing everything.... nuthin.
Yes that's good advice. Need to embrace the kiss theroy more.
I predict you're gonna love it! I probably would squirt the inside with degreaser and brush it with a tooth brush, just because.
Posting Permissions
| BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
| BR | Bench Rest | M | Magnum | RN | Round Nose |
| BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
| C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
| HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
| PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
| LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
| GC | Gas Check |
Reply With Quote