A few months ago I bought a Star off a forum member, can't remember who, and didn't get to use it until just this last week.
Bought a bunch of Lar's new Carnauba Blue lube which doesn't need a heater, loaded the star up and had at it, worked OK for a 40 or so boolits the started having an issue with injecting lube into the groove on my boolit, upon examining the press I got a lot of slack in the ram which move the arm going down to the lube piston!
On either end, depending which way I push the lever, I get about 1/4 inch air gap between ram and lever, wondering if I have a collapsed spring on my lube piston???
Question is how do I get it out and what is it's length supposed to be?? it looks like this one has a pin of some type in it but it doesn't go through to the bottom of the sizer, I can't post Pictures but can sure E mail them if some one needs a look see to give me an answer!
HM