NOE gas check seater die inventory run

[tzzler44]

Like a lot of you, I've got a couple molds that cast GC shanks that are a little tough to get checks on by hand. A few of us are trying to get Al to do an inventory run of the gas check seating die if anyone else is interested -http://noebulletmolds.com/smf/index.php/topic,1516.0.html

Link to the interest thread -----> http://noebulletmolds.com/smf/index....ic,1516.0.html

Mods, sorry if not allowed!

[deepwater]

I would be interested in a NOE gas check seater die.

deepwater

[JMax]

Why don't you put a dime on the sizing die and use the proper punch and seat those tough gas checks that way, It works for me and only cost s a dime?

[tzzler44]

Because Al's stuff is awesome.

But honestly because I would rather have a purpose built tool

[AbitNutz]

I'm totally unfamiliar with this...can someone point me at a picture?

[Greg S]

I'd be interested.

[tzzler44]

I'm totally unfamiliar with this...can someone point me at a picture?

check here ---> http://castboolits.gunloads.com/show...k-seating-Tool

I updated the first post to include the link to the interest thread on NOE's site

[Intel6]

I have had one for a few years and it is the best thing ever. I use a Star lubesizer but still buy his nose punches for GC bullets so I can seat them using his seater.

[DrDucati]

so, is the NOE seater caliber specific? Need to order separate punch or die for each bullet type?

[MT Chambers]

Not caliber specific at all, just use a flat punch at the bottom, the top die is just a holder for your top punch, although it is free floating to align properly.

[JMax]

My pocket change solution.

[dragon813gt]

My pocket change solution.

You can end up off center doing it that way. RCBSs makes a piece that limits travel so you can seat the check but not lube the bullet. The advantage to the NOE die is that the stem floats. The top punch will center itself and seat the check square. I have one mold that gives me problems seating checks if I use anything but the NOE die.

[Pilgrim Sojourner]

I'm interested as well. Here's the link for more info on the die from NOE:
http://noebulletmolds.com/NV/product...products_id=33

[tzzler44]

All those who are interested should also post in the inventory run thread on NOE's forum. I put the link in the 1st post.