OK I am pretty green at casting and seem to have run into a problem! I cast about 1000 of the Big Lube Dutchman bullets for my 44-40's about 4 months ago. Finally got around to trying to lube size them to .430 on my Star sizer. First bullet in I smeared a little lube on and pushed it into the sizing die, it seemed to get real tight the end of the stroke but I went ahead and put another bullet in and pushed it to the first bullet and now have two bullets stuck in the die. Used a punch to gently tap the die out of the star. Have not removed the bullets from the die yet but am concerned about the bullets I am trying to size. Measured about 50 of the bullets and they measured from .433 to .437, most around .4345-.435. Are these to large to size to .430 in one step? What would be my next step, besides removing the bullets from the die.
Jim K.