I've posted a question in the alloy section about how my molds are dropping slightly under weight bullets with a certain alloy. These are coated using Hy-Tek and then used and sold for IPSC completion, with powerfactor being an important part of the game at major matches I want my bullets as close to the advertised weight as possible. Just to be clear this is a small scale manufacturing company, personally I'll just bump my velocity a bit to be sure but customers are finicky about advertised weights and I want to give them the best product possible. When lapping a couple hundred thousandths will the weight increase? Only looking for a grain increase. I have 3 sets of 8 2 cavity molds for my bullet master, this is not gonna be a quick process but it will be worth it in the end if it produces a better bullet.
Thanks for any input you might have.