Always wanted a lighter set trigger pull on the GPR .54 but the adjustment screw wouldn't cooperate.
Read on one thread here about getting a longer adjustment screw and - problem solved. So, took my short stock adjustment screw to Home Depot and then a good hardware store.
The hardware store had a screw of the right diameter (I think) but the pitch was wrong, as it would not screw in very far when I brought it home.
Does anyone have know the correct size thread for the adjustment screw?
And where I could get one?
Yup, I could always drill and tap but I would prefer not to go that way.
Thanks for advice.
Jerry