Hey everyone,
I wanted to start a thread to throw around some ideas for making a PID controller for my shot maker which runs two propane burners. Firstly my understanding is this would require two pid controllers to control both valves I plan to install.
http://www.ebay.com/itm/Methane-Gas-...item3a80a635d7
the valve in question will be run inline with a T fitting before it and a ball valve running off the extra part of the fitting. This will run a small amount of propane to the element acting as a pilot light.
for this to work I planned to drill and tap a second feed line into the bottom of my propane bunner and run a small piece of copper line.
I was also looking at this PID controller with the 4" k type probe.
http://www.ebay.com/itm/DIGITAL-PID-...item3cd5eada22
I have looked up the wiring diagrams and I just need to understand that if I run the valve as a on off switch similar to the LEE pots on a PID controller if everyone thinks it will work or not, I am just starting to collect parts so I am open to suggestions as I am new to the PID controller world.
Thanks
Jeff