Ok here is my problem :
I am using magma blue temp at 126 deg pid controlled, air pressure at 65 psi.On my 357s and 9mms I keep getting what i call a pin hole that the lube will not flow into, on my 44s and 45s i do not have this problem. here is what i have tried so far and running out of ideas:
Ran heat up and down one degree at at time down to where lube wouldn't flow and up till lube was to the point of falling out of lube grove .also made air adjustments up to 130 psi. 126 and 65 PSI is where it seems to be the best but still darn pinhole on 60%of my bullets ! i have also tried another die in 9mm and 357 still have the darn pin hole, i HAVE ROTATED THE DIES TO SEE IF THE PIN HOLE MOVES POSITION IT DOES NOT, LOOKING DOWN AT THE DIE IN THE MACHINE THE PIN HOLE WOULD BE AT THE 6 OCLOCK POSITION, EVEN WARMED THAT AREA WITH A HEAT GUN STILL NO CHANGE , any ideas and help would be greatly appreciated as i am out of ideas ! HAS MY WIFE SO FRUSTRATED SHE DOESN'T WANT TO SIZE THOSE TWO CALIBERS