I have a savage model 11 in 308, and is slugged at .308 measured with a micrometer. Should I size my boolits in the .308 or .001 over?
I have a savage model 11 in 308, and is slugged at .308 measured with a micrometer. Should I size my boolits in the .308 or .001 over?
.310 generally works in all my 30 cal rifles newer than 1950
The mold that I have spits out a .309 would I even have to size it then
I would say no. Use a .309 die just to crimp the gas check on. This should not size your boolit.
A gun is a tool, Marian; no better or no worse than any other tool: an axe, a shovel or anything. A gun is as good or as bad as the man using it. Remember that. - Shane
Men occasionally stumble over the truth, but most of them pick themselves up and hurry off as if nothing ever happened.
Sir Winston Churchill
The truth that makes men free is for the most part the truth which men prefer not to hear.
Herbert Agar
434-1
Ok thanks
I still recommend a .310" die. It's OK for the gascheck to be a little larger than the boolit when you have a .310" throat... which is SAAMI spec for a .308W.
MJ
It's not about gun control, it's about people control. The progressives are using terrorists and the insane to further their agenda. If the socialist news media wasn't complicit, we could sit back and watch Fast & Furious and Benghazi-gate unfold.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |