So I've always hated that stupid red container that goes on top of the lee sizing dies. When you size boolits with a large flat nose they tend to stack and knock the top of the container off, spilling boolits all over the bench. So I did this
Mounted el cheapo $20 single stage press to a piece of 2x4
Then clamped the 2x4 in my bench vise so the press is mounted upside down.
Then put a piece of tubing over the end of the sizing die.
The bullets get put in the sizing die nose first. This in itself makes sizing go twice as fast. They get pushed through the sizing die and slide down the tube into my fancy dollar store bullet boxes.
: