hi everyone, i demill shotgun shells that have something wrong with them. i have a powder that was used in 12 ga 00b loads. i believe it to be very close to lil gun. is anyone interested in it? thanks
hi everyone, i demill shotgun shells that have something wrong with them. i have a powder that was used in 12 ga 00b loads. i believe it to be very close to lil gun. is anyone interested in it? thanks
Is it all from the same lot of the same brand of shells? If not it is very likely you have a mix of several powders which may vary greatly in speeds.
Reloading Data Project - (in retirement)
http://sourceforge.net/projects/reloadersrfrnce/
Interested
i have approx 50lbs of lil gun (?) some blue dot (10lbs),some shotgun piowder from fiocchi 1 3/4 oz lead loads, i havnt worked this powder yet to see where it falls on the burn rate chart but would expect it to be a slow shotgun powder. any interest can email me ddhotbot@hotmail.com thanks don
Where are you located? Send by way of PM if you do not wish to post your location here.
Thanks
300
As I was told when I was a child; your elders will make you smarter if you listen. Then when you are older your elders will teach you WISDOM.
300winmag
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |