I was PM'ing back and forth with a couple of members and told them I would make a post of how I make mine without the real need for special tools, so here it goes.
This picture shows what I used to cut the scrap 308/06 cases to a bit over 1.260 in length.
Once I had just a few cut I trimmed them to length (1.260 -.01) and brought them in the house. I know it looks as though it has a real big chamfer on the O.D. but I didn't adjust the cutters for this and left them as is.
Once I got my press bolted back to the table I used a 40cal carbide sizer and sized them down just far enough so that it's neither to much or to little to chamber in the barrel for my 1911.
After I got done pretty much neck sizing them I got a regular 45acp case next to them for comparison.
Now I put in the primer in all of them (5) and put in 6gr of Bullseye powder. After I got the powder in I used a 44mag case and just rested the case on a piece of cardboard and tapped the case down which cut out the wad I use to place over the powder.
Once I got the wad shoved in the case I put in 120gr of #8 shot in the case.
For the overshot card I used an old time card, I've also used those hard paper inserts that come in magazines as well, pretty much what's handy and harder and thicker than regular paper which you don't want to use. For making this I grabbed a 9mm case and tapped on it the same as the 44mag case I used earlier for the wad in order to make the over shot card.