Just got done casting some .44 bullets from a new RCBS 44-250-K mold. I used wheel weights for alloy and the bullets weigh 263-264 grains. These will be loaded in a 44 magnum. Im not sure what to do? What load data should i use? I never expected them to cast this much too heavy. My lyman book has a load for 265g jacketed bullets i could work up from. Or i have been thinking of making a jig for my milling machine, and drilling out the nose of the bullets to get them to 250 grains, but that will be a lot more work. I have 231, 296, clays, unique, red dot, blue dot, green dot, 800x, and wsf powders on hand. Anyone have any suggestions?