I can not get the Sprue Plate to sit flat enough so that when I cast it has wings around the base.
Is there someone that could make this thing right so it can be used? Or is it even worth it?
Thank You.
I can not get the Sprue Plate to sit flat enough so that when I cast it has wings around the base.
Is there someone that could make this thing right so it can be used? Or is it even worth it?
Thank You.
If one sits in thundering quiet the soul dies slow instead of yell to the heavens for all to hear and behold the righteous and upstanding and ones of which should be held with tales of woe. By C.A.S. <--- Thats Me lol.
If this has the old thin sprue plate on it buy one of the Lyman mold rebuild kits and install it, it has a much thicker plate that is great. Also leave the sprue plate screw a little loose so the plate swings easy. If you hold the mold up to the light so you can see the side of the mold and the sprue plate you will be able to see when the screw is too tight as the will be light between the two.
Another thing to do is take a 10-32 bottom tap and run it in the hole for the sprue plate lock screw. All of these I have checked were tapped with a taper tap and the allen screw would not screw in far enough to actually lock the sprue plate screw in position. You can check your by removing the sprue plate screw and try to run the allen screw in all the way. If it binds up just as it enters the hole for the SP screw it needs to be tapped out.
hone it I do it to ALL molds. Make sure its very fine FLAT stone
What about the Sprue Plate Stop? Can it be removed?
If one sits in thundering quiet the soul dies slow instead of yell to the heavens for all to hear and behold the righteous and upstanding and ones of which should be held with tales of woe. By C.A.S. <--- Thats Me lol.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |