I have a Magma 100 lb pot off a Bullet Master that I would like to use but there is no temp control and the heating elements have been replaced by one which hangs in over the side. I am told that I can buy anything I need from Grainger but what do I need? My plan is to build a frame for it and use it for bottom pouring double cavity molds. At one time I had a Bullet Master and still have several molds for it that I would like to use. Anyone ever do anything similar?
My first post here.
i would put a PID system on it, http://castboolits.gunloads.com/show...o-4-20-furnace. the link will tell you what you need to know. there is also other stickies around for PID temp controllers.
Welcome to the forum. I think you can do whatever you dream up with that set up just make sure it is steady because nobody wants 100lbs of lead on their feet. A PID controller is the way to go for sure. I have one on each of my pots and also on my master caster. They are not expensive but I would make sure the pot works before investing in whatever mods you choose to make.
"The only way to deal with an unfree world is to become so absolutely free that your very existence is an act of rebellion."
- Albert Camus -
A couple of pictures of what you have would be helpful. Also knowing the power draw (volts and amps) for the heating element would be necessary for any type of temperature controller.
DougF
You can get almost anything from Grainger for sure but what are you referring to? Pics will be very helpful as words often loose accuracy. Be careful as 100# of smelt has much energy and can hurt...
Liberalism is the triumph of emotion over intellect, but masquerading as the reverse.
I don't know how we ever shot maximum loads before P/C come along and saved us all. R5R
"No mosque in the United States flies an American flag."
"Dueling should have never been made illegal in this country. It settled lots of issues between folks."- Char-Gar
Welcome to the Forum !
I have never seen a Magma 100 pound pot from the Bullet Master other than a small advertisement diagram. Could you show us a couple photos of yours?
Jerry
S&W .38/44 Outdoorsman Accumulator
it's listed as a 90 lb pot for the automatic machine.
you can build a frame from angle iron to make a bottom pour pot.
i made one for one of my 40 lb pots to use for hand casting.
Posting Permissions
| BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
| BR | Bench Rest | M | Magnum | RN | Round Nose |
| BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
| C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
| HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
| PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
| LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
| GC | Gas Check |
Reply With Quote