Hi guy´s, I´m new at this stuff, and trying to learn a bit.
So if I come of as I don´t know a darn thing, that´s exactly right!
Well, I´m getting a Marlin 444p in a few days, and I´m staring to gather up equipment and knowledge to start casting my own boolits.
So far, so good.
However, we have the same problem over here in Sweden, as you guys have over there, the wheel weights made out of lead are geting really hard to find.
So, I have this lead wire, it´s pure lead. And, I have a lot of old plates and stuff that are pure tin.
Is it possible to alloy these two, to get a hard enough cast bullet for use in a rifle?
If not, what else should I be looking for, to get a good alloy?
Thank´s in advance!
Dennis