Anyone know of a source of bulk hollow base wadcutters in .44?
Not really wanting to pick up a mold and start casting them until I find out if they will work reversed in my Taurus Tracker M44C 4" .44 mag.
I plan on loading them to .44 special velocities using IMR Trail Boss. I've been having really good luck with hard cast SWC's and Trail Boss. Getting under 2" groups at 25 yards with the combo.
The hollow base full wadcutters work reversed in .38 special as hollow points but as just about everyone that's tried it has found out you gotta keep the velocity WAAAAY down or they tumble and aren't effective as hollow points.
I'd like to try the same experiment with some .44's and see where the tumble point (if any) comes out load wise.
Jim