A friend gave me about 50 lbs of shot reclaimed from a trap range.
Is shot hard enough to cast into bullets or would I have to alloy it with a hardener?
If so. . . . .what should I use?
A friend gave me about 50 lbs of shot reclaimed from a trap range.
Is shot hard enough to cast into bullets or would I have to alloy it with a hardener?
If so. . . . .what should I use?
Last edited by Tallyman; 12-24-2011 at 10:06 PM.
I use quite a bit of reclaimed shot. Assuming a mix of chilled shot and magnum shot, antimony is probably 3 to 4%. Add a bit of tin, and treat it like wheelweights. Alloy from shot also heat treats nicely. I just water quench straight from the mould.
Thanks for sharing your knowledge. . .I will melt the shot down and cast as is. I load mostly 30 caliber bullets at 1600 to 1800FPS which should work just fine.
Thanks for sharing your knowledge. . .I will melt the shot down and cast as is. I load mostly 30 caliber bullets at 1600 to 1800FPS which should work just fine.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |