morning folks,
yesterday i recieved a NEW set of Arg 7.65 dies, so i decided to try and reform some 8mm brass ,i annealed the cases, trimmed to approx lenght ,lubed a tad and ran a couple through the sizing die, and trimmed again to the book lenght (2.100)the results were dissapointing.
after using the 30cal "M" die to get a good start i hand seated a 311284 and tried to chamber it for a seating measurement the sucker wouldn't chamber even with using all my force to close the bolt .
my question ,,, what am i doing wrong ?.
or are these 7.65 arg dies or just a generic 7.65 dies stamped arg ?
they clearly state 7.65 ARG.