I have a question for those of you that have Quick loads.
I'm loading a cast PB boolit with an average hardness of BHN 18 in 38 special brass for my Marlin 1894c with cci SP primers to an oal 1.520"
I am using 10.0gr of Alliant 2400 atm - I am getting decent accuracy, about 3/4" at 50 yards.
Where am I looking at pressure wise and would it be safe to push the load a little.
I do not have access to a chrony - so I am looking carefully for overpressure signs. So far the brass is showing no signs of excessive pressure.