l was advised to come here for help. l have cast some bullets using an RCBS mold 38-158 gc. l sized and lubed the bullets to .357, installed gas cks too. l then attempted to push one of the sized bullets heel first thru the front of the cylinder. l could get part of the base in. lt was a very very tite fit tho. l did not try to force the bullet any further. The gun is an unfired 27-2.. l tried the bullet on another well used 27-2 5'' and my 40 year old mod 36 Smith . l got the same results
Question is ---Should l size these bullets down to .356 or is .357 the way to go ??
thanks