Hello everybody!
I picked up a Saeco 301 SC on ebay. It was loose so I tapped in the pins a tad & carefully filed off the hump around the pin hloes to flush. but I can see day light through the mold at the cavity from top to bottom and not ot the ends .
I guess its warped a tiny bit. I havent cast it yet. Can I clean this up with a very flat surface and a bit of fine sand paper?? any Ideas are WELCOME..... Thanks buck
............I'd try casting with it first. You may get good useable boolits. Also when heated it may 'warp' back into perfection! If it doesn't close up and it doesn't fin or have whiskers it will be fatter in the middle
............Buckshot
Father Grand Caster watches over you my brother. Go now and pour yourself a hot one. May the Sacred Silver Stream be with you always
Proud former Shooters.Com Cast Bullet alumnus and plank owner.
"The Republic can survive a Barack Obama, who is, after all, merely a fool. It is less likely to survive a multitude of fools such as those who made him their president."
Shrink the State End the Fed Balance the budget Make a profit Leave an inheritance
Posting Permissions
| BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
| BR | Bench Rest | M | Magnum | RN | Round Nose |
| BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
| C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
| HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
| PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
| LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
| GC | Gas Check |
Reply With Quote