Years ago I obtained an old Ideal mold 219247. This is one which has the handles as part of the mold, It is in excellent condition except some troll used it to hold a steel wire or something similar and left a dent in front of the nose. This dent is just a little off center of the nose and is about 1/32+ in diameter and about 1/16 deep. The rest of the cavity is sharp and in like new condition, even the sprue plate screw and lock screw look new. I have a 32-40 and I would like to use this bullet. My question is, can this mold be repaired, Any ideas are welcome, One idea; was to try to melt brass into the dents on each side and then hone them flat and dress the nose. I don't know if anyone repairs molds. This mold is so old and in such nice condition other wise I hate to junk it. HELP!