I ordered a mold from Dan Lynch of Mountain Molds back in February and it came yesterday. Like all boys with a new toy, I had to give it a test drive. Cleaned off the oil while the pot was heating and away we went. I have molds from several manufacturers and this is the best I have ever used. The bullets came out pretty and fully filled out almost from the beginning and I had no bad ones after the 4th batch of 2. Like a kid with a new toy I didn't stop until my other half yalled at me to come up for dinner. By then I had close to 500 very pretty little 7mm bullets. I highly recommend this man's work. I have not seen better in a mold. Mine is a two cavity iron and his price, $95, is more than reasonable for the quality. I got two nose punches to match, I tend to lose the things, and after sizing about 100 bullets this morning, I really began to appreciate a nose punch that actually fits the bullet.
This man does superior work.
The bullet was designed on his website design program. The bullet is a flat nose bore rider gas checked design for the 7-30 Waters in a 94 AE Winchester Carbine and weighs 125 grains w/ gas check.