juat ordeded two lee 105 grain swc six cavity molds.. My plan is to use for my 38 calibel for plinking loads, size down to .356 for my 380 and 9 mm. Should be a fun bullet. With two molds should be able to pump out a lot of bullets fast. Hope I am correct. Had the two cavity molds but was not fast enough. But I do like the bullets, using xlox for lube.
You can pump out allot of bullets with one mould alone. It is a very good acurate plinker. I like it allot. My first one gave me fits not dropping bullets good. I had to adjust it a bit with a hammer. I had a change of heart later though and fixed it and eventually replaced it with a new one.
Aim small, miss small!
looks like a fast one!
I got a lot of those that I use in my .380... Never used it in 9mm or .38spl but I hear that both like them!
Currently looking for a Lyman/Ideal 311419 Mold - PM if you have one you'd like to get rid of!
JDGabbard's Feedback Thread
"A hand on a gun is better than a cop on the phone," Jerry Ellis, Oklahoma State House of Representatives.
The neighbors refer to me affectionately as, "The nut up on the ridge with the cannon." - MaxHeadSpace.
Jdgabbard's very own boolit boxes pattern!
I've used mine in 38, 357 and 9mm - never tried 380 - it fed good in my Hi-power FEG clone.
Posting Permissions
| BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
| BR | Bench Rest | M | Magnum | RN | Round Nose |
| BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
| C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
| HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
| PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
| LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
| GC | Gas Check |
Reply With Quote