Here is one I made. I have since put a piece of half round on it for a push piece and an end to a piece of dowel to knock the bullets lose. It is a 45-70 case with the primer pocket drilled out with a 16D nail as the ejector.
|
   
   
|
|
Here is one I made. I have since put a piece of half round on it for a push piece and an end to a piece of dowel to knock the bullets lose. It is a 45-70 case with the primer pocket drilled out with a 16D nail as the ejector.
You can miss fast & you can miss a lot, but only hits count.
Got the shaft at Goodwill, cut it and found that it was very thick material and even inside diameter at the top of the shaft was too small. My wife looked at the cut up golf club and looked like she was going to ask, but changed her mind.
Then I remembered that I had purchased a golf club ten years ago (just so I could try out driving balls) and found it in the garage. It is now a kake cutter that holds probably 25 boolits before they start popping out of the top.
Thanks Eduba for the great idea!
Randy
Posting Permissions
| BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
| BR | Bench Rest | M | Magnum | RN | Round Nose |
| BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
| C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
| HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
| PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
| LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
| GC | Gas Check |
Reply With Quote