i have been using this stuff since i began casting. it is very easy to use, and seems pretty adequet for most of my handgun boolits. the question i have is, do you stand your boolits on end to dry, or just toss them however they come out of your container, and leave them lay on their sides. for the most part, i had been standing each boolit up, so the coating would be similar (concentric) all the way around, and not thick on the bottom, and thin on the top. but when i am doing several hundred boolits, that is a real p.i.a. ! since i started casting rifle boolits, i just leave them lay on their side. but most of those i install gas checks on, so the lla gets pushed around / smeared off or through by the sizer anyway. i also hand pack all of the grooves with grease after installing the gas checks (i REALLY need a lube-sizer) which is horribly time consuming and messy, but just a couple of coats of lla after installing the gas cheks doesnt really seem to do the job. i end up scrubbing lead from the barrels if i do that. yah, i know,! but anyway, what do you guys do? leave them lay, or stand each boolit up?