I have a rcbs 300gr 45 rifle boolit mold that casts .458 and want to lap the molt to increase the diameter to .460. I have silicon carbide lapping compound starting at 220 grit all the way up to 1000 grit. Any suggestions are appreciated. Frank
I have a rcbs 300gr 45 rifle boolit mold that casts .458 and want to lap the molt to increase the diameter to .460. I have silicon carbide lapping compound starting at 220 grit all the way up to 1000 grit. Any suggestions are appreciated. Frank
.002" is a long way to lap, in my limited experience. I would suggest Beagling (shimming) the mould with strips of aluminum tape. You will need to tape both faces of the mould to get .002" I would guess.
I beagled a mold and got .004 before I started flashing, I was using ladel pour.
Some where between here and there.....
redneckdan---You beagled a mold and got .004 before you started flashing. How big a crowd did you flash? You get on tv?
If it doubled, it would have been .008.Originally Posted by carpetman
Is that considered a big crowd?
CM
Last edited by montana_charlie; 04-11-2006 at 09:57 PM.
Retired...TWICE. Now just raisin' cows and livin' on borrowed time.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |