I have an old SAECO Model 24 that used to work good until one day it started
dripping and running and you could not stop the flow out the bottom.
When it was empty and cooled down, I noticed there was what looked to be a small "cone" shaped piece of metal (aluminum?) laying in the spout hole.
It appears that this fit over the reduced diameter at the bottom of the valve shaft
and sealed the valve seat at the bottom of the pot.
What is this valve made of and how do I replace it. How was it held on?
If you place it on the shaft, it will fall off first time you try to use it. It is also very worn and rough.
HELP!!! I love this pot and don't want to give it up! How can I fix it???
Wayne