Thanks for all the suggestions.
I will try to get to it and take some picture.
|
   
   
|
|
Thanks for all the suggestions.
I will try to get to it and take some picture.
I lathe turned a couple ends from brass as it was all I had at the time. Worked fine.
3/4" copper round $4.28 per inch plus shipping. I would check Home Depot for grounding rod first before spending $$ on this. You'll probably need minimum 3" to make a couple ends.
https://www.speedymetals.com/pc-2944...10-copper.aspx
For the power cord I bought a 30 foot RV 50 amp cord. It runs on a separate 50 amp 220vac outlet.
Had some time, inbetween the rain, to open it up.
Looks very clean inside.
Plug is just a tapered pin.
I took one out to take with me to the welding shop.
Wish me luck.
Posting Permissions
| BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
| BR | Bench Rest | M | Magnum | RN | Round Nose |
| BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
| C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
| HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
| PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
| LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
| GC | Gas Check |
Reply With Quote
