WTB - .32 Win SPL Mold

[Jkrem]

Looking for a Lyman or Ideal mold to cast boolits for a .32 Win SPL. I had three molds that I sold here several years ago, and of course now my son bought a Winchester that I need to load for. Candidates might be:

321232
321297
321265 - non-hollow point or hollow point

Will consider other similar molds in the 150-170gr range, or suggestions!

I could also use a Lee (or other) .321-.323 push through sizer.

Thanks very much.
Jim

[floydboy]

I'm in the same boat right now. After searching for a used Lyman or RCBS mold I ended up buying a RCBS 32-170FN. Had to buy a new one...OUCH. I am very happy with it. Dropping boolits in the .323-.324 range with my alloy so I can size at .323. Waiting on a .323 sizing die for my Star sizer and I'll be good to go. Had to buy reloading dies off Ebay....OUCH again and had to pay almost new prices to get them but they are in almost new condition. Waited for 3 weeks for that rcbs mold to show up somewhere before I bought it new. Just a heads up. Inventorys on the mold are in the 2-3 unit range. If you decide to get one good luck. Floyd

[Good Cheer]

I have one of the original Winchester molds in pretty darn good condition.
The sprue plate was warped so I straightened it and did some smoothing down to make it fit well to cast boolits.
If interested shoot me a message.

[oscarflytyer]

Just sold one for the 32. But might also look for Lyman 319247. Technically listed for a 32-40, but supposed to be .322. 165 grn flat base.

[LeonardC]

I saw one from Midsouth on RCBS sale for $117.89, regular price $130.99; unfortunately out of stock now. Midway has the RCBS mold in stock for regular price of $164.99

[bear58]

Sent you a PM