Lee PrecisionRepackboxReloading EverythingInline Fabrication
MidSouth Shooters SupplyTitan ReloadingSnyders JerkyWideners
RotoMetals2 Load Data
Results 1 to 3 of 3

Thread: What can you make 50/95 brass from?

  1. 12-19-2023, 06:18 PM #1
    koger
    koger is offline
    Boolit Master
    Join Date
    Apr 2008
    Location
    Monticello, KY
    Posts
    1,738

    What can you make 50/95 brass from?

    Thinking about buying a mint Uberti 1876 50/95, Dies are available with it, but no one has brass that is affordable in stock, what can you make it from?
    Reply With Quote Reply With Quote
  2. 12-19-2023, 07:08 PM #2
    FLINTNFIRE
    FLINTNFIRE is offline
    Boolit Master

    FLINTNFIRE's Avatar
    Join Date
    Apr 2012
    Location
    Longview, Washington
    Posts
    1,662
    I used 50 alaskan , bought a small cut off saw from harbor freight , replaced saw wheel with a grinding disk , cut then chamfer and deburr then size in dies then trim to length on case trimmer then chamfer and deburr , could probably skip deburring before sizing or size after trimming , but that is how I did mine .
    Reply With Quote Reply With Quote
  3. 12-19-2023, 08:21 PM #3
    koger
    koger is offline
    Boolit Master
    Join Date
    Apr 2008
    Location
    Monticello, KY
    Posts
    1,738
    Thanks.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check