Got a ped. Rolling block in 45-70. I’ve got a very accurate load using 1.5 swiss .060 wad with
.100 of compression. Get home to clean and there is always a few slivers of lead in bore. Using
A baco 459535m3 and spg lube. It will shoot 1 moa even with the slivers. Question is since their
Chambers run long at 2.150 and brass runs 2.100 if your lucky could the .050 of chamber exposed
Be my leading problem. I’ve tried 4 different bullets in this gun and they all lead basically the same.
Accuracy is always good, just tired of tapping lead out with turpentine and tight patch. The only other thing I haven’t tried was a .458 dia bullet.