lee 311-100-2R in 7.62x25 tok?

[rufracer]

has anyone tried this combo? What is the nose lengtht?

[9.3X62AL]

I bury a moderate roll crimp dead-center into the drive band between the lube grooves, and things go well in a Broomhandle, a ChiCom Type 54 Tokarev, and the CZ-52.

[yodar]

I bury a moderate roll crimp dead-center into the drive band between the lube grooves, and things go well in a Broomhandle, a ChiCom Type 54 Tokarev, and the CZ-52.

311359 is a darn good bullet in my CZ 52 1252 fps over 6 gr Power Pistol

THE LEE 90 GR r n works too, but the 311359 looks downright WICKED



yodar

[jdgabbard]

has anyone tried this combo? What is the nose lengtht?

Thats the combo I use, along with a pretty healthy dose of H-110 on top of a mag primer. I get about 1500 fps out of that load. A note on that load, that is with cut down and resized .223 Remington brass. I wouldn't try loading anything that hot with a 100g boolit at that velocity. Its almost, if not a max load. Not to mentioned takes a little effort and playing with it to compress the powder enough to get it seated right.

As for nose length, I'm kinda stuck up north for the remainder of the week (going to school), if you would have asked yesterday morning I could get that info for you

But when I go back down this weekend I try and remember to get that data for you and post it. If someone else doesn't before me.

[mag_01]

Like the boolit and have used it with 6.5 herco in 7.62x25 tok. (cz52)

Tom

[wonderwolf]

I've been looking for load data on the 120gr (115?) 311359 GC bullet as I have reloadable 7.62 brass and a few of those bullets put back waiting on the data.

Any load data for that combination with other powders?