.314", two cavity, gas checked, semi-wadcutter Magma Engineering bullet mold. It's marked 32-20-115-RNFPGC. No pitting, no rust, if you look very closely at the interior of the mold under a bright light you
can see on each side of the mold a very small, (about .070x.020") shiny spot where a small amount of lead got onto the mold, I removed the lead with a small piece of copper scouring pad. With a gas check this mold makes a bullet more like 120 grains. Makes nice looking bullets. Shoots OK in my revolver, (1.25" groups with start charge of Titegroup at 25 yards). but I think it would really shine in a 32 caliber rifle. $60.00 shipped. USPS m.o. or another m.o. if that's too much trouble or a personal check if those first two are too much trouble.
* * * SOLD TO ReloaderFred * * *