32 cal. Magma. Eng. 115 Gr Bullet Mold

[silhouette_shooter]

.314", two cavity, gas checked, semi-wadcutter Magma Engineering bullet mold. It's marked 32-20-115-RNFPGC. No pitting, no rust, if you look very closely at the interior of the mold under a bright light you






can see on each side of the mold a very small, (about .070x.020") shiny spot where a small amount of lead got onto the mold, I removed the lead with a small piece of copper scouring pad. With a gas check this mold makes a bullet more like 120 grains. Makes nice looking bullets. Shoots OK in my revolver, (1.25" groups with start charge of Titegroup at 25 yards). but I think it would really shine in a 32 caliber rifle. $60.00 shipped. USPS m.o. or another m.o. if that's too much trouble or a personal check if those first two are too much trouble.

* * * SOLD TO ReloaderFred * * *

[wc870]

pictures ?

[silhouette_shooter]

I tried but received an error msg that the upload failed, maybe because of my non-paying member status.

[gmsharps]

sounds like the file was too large to upload

gmsharps

[silhouette_shooter]

Good thought, I'll try a picture with my $14.00 Walmart phone. Thank you gmsharps . . .

[ReloaderFred]

I'll take it. PM on it's way..

[silhouette_shooter]

Sold to ReloaderFred