I often hear and read that wadcutters were designed for paper punching. That is not correct. Currently in the US that is their primary function. Specifically for NRA Bullseye Handgun competition. They work great out to 50 yards and the leave a paper punched type hole. As long as the hole touches the next higher scoring ring it counts. Full WC's do this better than SWC's or any other bullet design.
Historical I am not sure when the design was first introduced but the Brits used a hollow base hollow point in the .455 Webley manstopper load than later used a flat nose WC.
http://cartridgecollectors.org/?page...455-cartridges
It was about this time that the British Government became fixated with "stopping power" (remember the .303 Mk III - "Dum Dum" was approved for service in 1897 and it wasn’t until the 1899 Hague Convention that such ammunition was considered, well, unsporting.) This trend extended to the .455 revolver ammunition and, as a result, the Mark III .455 cartridge appeared in 1898. This has the same .760 ins case but the bullet had a deep nose cavity which reduced its weight to around 220 grains – referred to as the "Manstopper" bullet. Cordite was again the propellant of choice. Some Mark III cases were later loaded with Mark II (conical lead) bullets.
Obviously production of the Mark III was overtaken by international events and sentiments. It was removed from service in 1900 and the Mark II cartridge was re-instated as a stop-gap measure. Some lengthy experimentation then took place to come up with a more effective bullet and it wasn’t until 12 years later (1912) that the .455 Mark IV cartridge emerged. This used the same case as the previous marks, with a cordite charge and the bullet was 220 grains but with a completely flat nose – basically a full wadcutter in today’s terms. At this point it should be noted that the collector may encounter .455 cartridges which have a bullet nose that is slightly rounded rather than completely flat. These are not Mark IV rounds but commercial target rounds sometimes loaded on surplus military cases.
The same fear that had resulted in the Mark III "Manstopper" being removed from service resurfaced with the "wadcutter" Mark IV. As a result, the Mark II, reintroduced when the Mark III was withdrawn, remained the service cartridge until the introduction of the Mark VI (see below).
Despite concerns about the Mark IV, a Mark V .455 cartridge was introduced in 1914. This had the exact same bullet profile as the Mark IV but used a harder lead alloy. It was otherwise identical in construction to the Mark IV and the general consensus amongst military experts is that it was used solely for target practice. It was a very short-lived cartridge and remains quite rare. While headstamps indicating a Mark V case are not uncommon, these are normally found loaded with Mark II bullets.